Hydraulic cylinder operation is not stable reasons and measures

Hydraulic cylinder operation is not stable reasons and measures

 First, the reasons for the unstable operation of the hydraulic cylinder are as follows:

       (1) the oil pipeline is blocked, then the oil pipeline should be unblocked, and check whether the hydraulic oil is caused by the hydraulic oil, if so, to determine whether to replace the hydraulic oil.

       (2) the presence of air in the hydraulic system, this should be exhaust treatment and to discharge clean, and there should be no residual gas.

       (3) wear and tear of components: such as bearings or side plates, etc., which should be replaced in a timely manner.

       2, to avoid the hydraulic cylinder failure of some specific measures:

       Measure 1: The sealing device in the cylinder body is mainly seals should be selected appropriate hardness. And it should be noted that the higher the cylinder pressure is the greater the hardness of the seals;

       Measure two: for the sealing aspect, should pay attention to and choose to match, can't just choose more can't be used arbitrarily, because this will be a problem;

       Measures: to correctly and reasonably use the hydraulic cylinder, not blind operation and use, which will not only make it seriously damaged and will also greatly shorten its service life and may bring serious consequences so that the scrap can not be used, resulting in the loss of economic interests.