The installation principle and transmission principle of the hydraulic lifting device for storage tanks

The installation principle and transmission principle of the hydraulic lifting device for storage tanks

The hydraulic lifting unit is mainly used for the lifting project of engineering buildings (or structures). Different component combinations with the hydraulic lifting unit are suitable for the hydraulic lifting project of various types of large oil tanks (dome tanks, floating tanks, internal floating tanks, etc.). Due to the characteristic of the upper and lower chucks of this jack alternately tightening the support rods, there is no limit to the lifting height. If it is turned upside down, it can be used in heavy object lifting projects. So let's take a look at the installation principle and transmission principle of the hydraulic lifting device for storage tanks together!

The development of hydraulic lifting technology for storage tanks. The hydraulic lifting project of water towers and oil tanks adopts hydraulic lifting devices and different component combinations. The hydraulic lifting devices are mainly used for the lifting project of engineering buildings (or structures). It is applicable to the hydraulic lifting projects of various types of large storage tanks, such as dome tanks, floating roof tanks, internal floating roof tanks, etc.

It is difficult to describe the high and low operating temperatures of the materials for the hydraulic lifting device of storage tanks, as this is the result of a combined influence of a series of factors. The working temperatures of the piston and the piston rod are different. Please make a distinction when choosing. The level of pressure and the variation length of the pressure cycle have a significant impact on the damage (such as squeezing) of hydraulic lifting equipment. The higher the pressure, the greater the impact of other factors on the performance of the hydraulic lifting device, such as temperature, speed, hydraulic lifting material, the gap between the piston and the cylinder barrel, and the gap between the piston and the cylinder head, etc.

The hydraulic lifting device for storage tanks uses a manual booster rod (hydraulic manual pump) to release hydraulic oil into the cylinder through a single valve. The working principle of the hydraulic lifting device: The principle that even if the hydraulic lifting device transmits pressure, it will not change. At this point, the hydraulic oil entering the cylinder is a separate valve and cannot retreat further. Lift the piston rod upwards and continue working to allow the hydraulic oil to sometimes enter the cylinder.